Endevco
 
  • Reset
2016 | USA

Fundamental Understanding of Rotor Aeromechanics at High Advance Ratio Through Wind Tunnel Testing

2016 | USA

Sphere release from a rectangular cavity at Mach 2.22 freestream conditions

2016 | USA

Ignition limits of explosively dispersed fuel

2016 | USA

Unsteady pressure sensitive paint measurements of resonance properties in complex cavities

2016 | USA

Hypersonic wind-tunnel measurements of boundary-layer transition on a slender cone

2016 | USA

Synchronized Velocity and Pressure Measurements of Supersonic Flow over a Finite Span Cavity with Leading Edge Slot Blowing

2016 | Lithuania

Design, Research and Practical Implementation of the Laser Shooting Simulation System for 5.56 mm G-36, 7.62 mm FN MAG and 84 mm Carl Gustaf

2016 | USA

Mechanisms underlying long-term fear memory formation from a metaplastic neuronal state

2016 | Japan

Response comparison of FBG sensor, strain gage, and piezo-electric accelerometer in an aluminum cantilever beam shock load

2016 | USA

WSN Architecture

2016 | Israel

Bearing health monitoring using optical fiber sensors

2016 | South Korea

Influence of cross-sectional discontinuity on the damping characteristics of viscoelastically supported rectangular plates

2016 | Israel

Spall size estimation in bearing races based on vibration analysis

2016 | Germany

Callosal anatomical and effective connectivity between primary motor cortices predicts visually cued bimanual temporal coordination performance

2016 | Australia

On Line Condition Monitoring of Wind Turbine Generators

2016 | France

HUMAN FACE RESPONSE AT AN ANGLE TO THE FORE-AFT VERTICAL PLANE IMPACT

2016 | Finland

Detection of structure in asteroid analogue materials and titan's regolith by a landing spacecraft

2016 | USA

Comparisons between Forced-Response and Hysteretic Energy Damping Assessment Methods

2016 | USA

Improved Pre-Strain method for generating goodman data with Vibration-Based fatigue testing

2016 | TBD

Optimization Design of Printed Circuit Board Structure Based on Modal Analysis

2016 | Greece

Investigation of the dynamic mechanical properties of epoxy resins modified with elastomers

PCB PIEZOTRONICS


PCB® manufactures sensors used by design engineers and predictive maintenance professionals to test and measure vibration, pressure, force, acoustics, load, and shock in research and development as well as industrial applications.

ENDEVCO


The Endevco® brand is known for highly reliable products for test and measurement applications, including solutions for shock, vibration, motion, pressure, and supportive instrumentation. It was acquired by PCB® in 2019.

CONNECT

CONTACT


10869 NC Highway 903
Halifax, NC 27839

SensorlineSM
+1 716-684-0001

1-866-ENDEVCO

Endevco® is a registered trademark of PCB Piezotronics of North Carolina, Inc.

© PCB Piezotronics of North Carolina, Inc. All rights reserved